Categories
cnc parts

Wood engraving machine dust cover installed there is no need to buy?

When purchasing woodworking engraving machines, the configuration sheets given by the manufacturers generally have the opportunity to woodworking vacuuming. As an option, processing can be done without him. Remuneration woodworking engraving machine manufacturers suggest: vacuum cleaners and other woodworking vacuum cleaners are best installed at the factory, preferably selected.
To make the above choices, the main starting point is two points: one is the maintenance of the engraving machine, and the second is responsible for the health of the operator.
1, when the machine is processed, a lot of dust will be generated. If a large amount of dust is not processed, it will float to various places of the machine, such as rails and gear gaps. Many are not in a position to clean up in time, which creates a hidden danger to the machine. After using the vacuum cleaner, most of the dust damage can be avoided.
2, Although many operators wear masks, a lots of wood chips and powder float in the air. If you donot have to vacuum, the damage to the human body is still great.
Woodworking vacuuming equipment is not expensive. It is better to install it better.

Categories
cnc parts

How to adjust the height of the CNC lathe tailstock?

tailstock height adjustment

Height adjustment step:
1. Because the structure of the tailstock of the lathe is similar, if the height adjustment is necessary, the gasket has to be added.

2, the left and right skew adjustment is simple, you can adjust the screw left and right.

3. The height adjustment method of the tailstock is to draw a cylinder with the same diameter as the tailstock sleeve on the machine tool, then suck the table of the magnetic watch on the middle carriage, and then measure the height of the workpiece and the tailstock sleeve. Can.

4. Align the dial indicator with the horizontal center of the workpiece and move the heavy carriage to measure the workpiece and the tailstock sleeve to adjust. Finally tighten the left and right screws. If the machine guide rail is used for a long time, it will wear out. If you adjust it, it may be unsuitable for all positions. If the length of the workpiece is long, you need to fine-tune it after commissioning. It is used by a scrap as long as the workpiece you want to machine, and then look at the outer circle. Consider whether there is a taper at both ends, and adjust it slightly according to the actual situation.

5. The selected gasket is not suitable. The thickness has to be adjusted. It can be fitted by grinding the thickness of the gasket or adjusting the tightening strength of the screw.