Categories
cnc parts

Stepper motor running current and subdivision drive settings

The stepper motor defaults to one step to 1.8° angle, 360/1.8=200 pulses, so the stepper motor defaults to 200 pulses, but in some mechanisms the precision is high, 1.8° is not suitable, so there is The subdivision settings on the drive, for example, a 1000 (or 5) subdivision on the drive, that is, the angle is reduced by 5 times, that is, 1.8/5 = 0.36, which means that the angle of the motor is 0.36° per step.

This precision is increased by a factor of five. The current, the stepper motor has a rated current, for example, the rated current of a click is 4A, if you select 2.25A on the drive, then the motor’s strength can not reach its original torque, but you set it to 5A Although the strength is large, the relative motor heat is also increased. The current setting needs to be set according to the actual situation.

Generally, a small load has a low current and a small current, while a high load requires a large current.

There are no mathematical formulas, which are all set according to the actual situation.

This drive using the drive’s current loop subdivision control, the motor torque ripple is very small, low-speed running is very smooth, almost no vibration and noise.

Widely used in the engraving machine, CNC machine tools, packaging machinery and other high resolution requirements on the device

Leadshine Microstep Driver DMA860H Step Motor Driver 18V-80VDC 2.4A-7.2A for CNC Router

Leave a Reply

Your email address will not be published. Required fields are marked *